|Load Manager Mark II|
Cat. No. 091-60A
Load Manager Mark II Lamp
Sequencer, Load Shedding
• Automatically sequences lights on and off
• Automatically sheds loads to prevent system overload
• Eliminates power surges and sags in electrical system
• Contains 8 load relays, 30A load per relay
• Remote manual Override
• Load shed priority programmable
• Easy installation
The “LOAD MANAGER MARK II” is a precision solid-state controller, which
sequentially switches 8 self-contained relays at 1/2 second intervals.
Individual switches (user provided), can select the combination of
outputs. These switches may be used to turn the outputs “ON” or “OFF”
at any time. The “Master Control” switch starts the sequential
switching when it is turned “ON”. Similarly turning the “Master
Control” switch “OFF” sequentially de-energizes the loads at 1/2 second
In addition the “LOAD MANAGER MARK II” monitors the vehicle’s battery
voltage. When electrical loads exceed the alternator output, this
causes the voltage to drop. This is sensed and outputs are individually
de-energized. Up to 5 outputs are controlled. Only as many are shut
down as are required to maintain the system voltage. The shut down
sequence may be altered by programming switches internal to the “LOAD
MANAGER MARK II” and accessible through a removable cap.
An LED indicator signals when the “LOAD MANAGER MARK II” is active and
when in the “LOAD REDUCE” mode.
The provided output relays have both normally open and normally closed
contacts. This provides a variety of options for the installer.
|| Load Manager