|Intellitec Water Pump Controller Potted|
Cat. No. MT00-00776-200
Intellitec’s 15AmpWater Pump Control is one of MONOPLEX family of
devices. It offers many following benefits to water pump switching.
Minimizes the use of heavy gauge wire that runs through the coach. Only
two 14 gauge wires needed to connect to the power source to the pump.
Multipoint switching can be added any where along the single MONOPLEX TM
network, using simple wiring.
Simplified switches (momentary buttons) increase reliability.
Negligible standby current makes this system superior to conventional
multipoint relay switching.
Labor and initial installation costs are reduced compared to
conventional multipoint switching.
Potted assembly resists water damage.
The MONOPLEXTM 15 Amp Water Pump Control is
designed to operate as a “low side” remote switch in 12 volt DC
systems. As it’s name implies, it was designed to control the domestic
water pump. This unit will only work with loads greater than 5 amps but
less than 15 amps.
The unit is packaged in a plastic enclosure suitable for mounting in a
wet environment, such as near the water pump. It is capable of
operating from multiple switch points (as many as desired) and up to
100 milliamps of power indicators. Power can be supplied either from a
battery or a converter.
Part Number: 00-00776-200
Operating Voltage: 10.0 - 16.0
Current Carry Capabilities: 15A
Standby Current draw: 2
Operating temperature -40 C to
(-40F to +185F)
Operating Environment: Out of