|
Home: EcoVantage Catalog: Solar: Charge Controllers:
Schneider Electric (Xantrex) XW-MPPT Charge Controllers
Cat. No. XW-MPPTxx-xxx
Weight 12 lbs | |
XW-MPPT60-150 Charge Controller
The XW-MPPT60-150 can used with PV arrays with a voltage equal to
anything from battery voltage to 150 VDC and can support an output of
up to 60 amps into the battery for battery voltage of 12 to 60 VDC. The
PV open circuit voltage must not exceed 150 VDC.
Maximum power point tracking allows the charge controller to harvest
the maximum energy available from the PV array and deliver it to the
batteries. The MPPT algorithm continuously adjusts the operating points
in an attempt to fi nd the maximum power point of the array. The
algorithm can then determine if it is harvesting more or less power
than the previous operating points. The charge controller has a
configurable auxiliary output (producing 5 to 13 volts at 200 mA) to
drive a relay for load control or to turn on devices such as vent fans
or indicator alarms. The auxiliary output can be configured to perform
only one function at a time.
Its large aluminum heatsink allows it to operate at full power with
only convection cooling, without the need for a fan. Built-in PV ground
fault protection allows code-compliant installation without the need
for additional ground fault protection. The XW-MPPT60-150 can be
mounted on the side or top of the XW power distribution panel, or used
by itself in other PV systems. The front panel features a 2-line
16-character display and four buttons for configuration and system
monitoring. A battery temperature sensor is included with the
controller.
The XW-MPPT60-150 is able to
communicate its settings and activity to
other Xanbus-enabled devices, such as the XW Series inverter/charger,
the system control panel II (SCP), XW automatic generator start
(XW-AGS), and other Xantrex XW-MPPT-60-150 solar charge controllers
through the Xanbus network.
Array size can be up to 750 watts when charging a 12-volt battery,
1,500 watts when charging at 24 volts and 3,000 watts when charging at
48 volts. Dimensions are 14 ½"H x 5 ¾"W x 5
½"D and weight is 12 lbs. 5-year warranty.
XW-MPPT80-600 80A MPPT solar
charge controller. Max Open Circuit voltage 600VDC, MPPT range 195 -
550VDC. Suitable for 24 & 48V Battery banks. UL/CSA/CE approved 5
year warranty
|
|
|
