|Magnum Hybrid Series, Renewable Energy Version|
Cat. No. MSH4024RE
Weight 60 lbs
The MSH-RE Series Inverter / Charger from Magnum Energy – a pure sine
wave inverter that combines the tried and tested engineering of
Magnum’s MS line with hybrid technology to make it an optimal choice
for your renewable and backup power needs.
Hybrid technology: Most inverters only use one source of energy to
power loads, either from incoming AC power – utility or AC generator –
or from the batteries. The MSH-RE Series combines the energy from both
sources to power loads. This allows the inverter to recharge the
batteries when there is surplus power or deliver more power to the
loads if they require more than the AC input can supply by itself.
Load support: Load support parallels the inverter output with incoming
AC sources allowing it to run larger loads from smaller generators.
Pure sine wave: Power your T.V.s, stereos, plasma screens, and other
sensitive electronics without worry. The pure sine wave inverter and
power factor corrected charger provide clean, reliable inverter power
with low total harmonic distortion (THD) of less than 5%.
Easy-to-install: Install the
MSH-RE Series in four easy steps: simply connect the inverter’s output
to your distribution circuits or electrical panel, connect your utility
power cable to the inverter’s easy-to-reach terminal block, connect the
batteries, and switch on the power.
Dual AC inputs: The MSH-RE Series comes with two 60 amp AC inputs – a grid input at 60A and a generator input at 60A.
Accessible design: The extra
large AC access cover with terminal screw block and 360° DC
connection terminals with covers make this inverter more accessible
when it needs to be.
The MSH-RE is interchangeable with the Magnum MS Series and uses the same accessories as the MS Series.
Lightweight: The lightweight aluminum base and cover also provides noise reduction and corrosion resistance.
Multiple ports: The MSH-RE Series provides multiple ports, including an RS485 communication port for network expansion, and a remote port.
Convenient switches: The MSH-RE Series comes with an on/off inverter-mounted switch with an easy-to-read LED indicator.
Buy with ease: The MSH-RE
Series is backed by a three-year (36-month) limited warranty, and a
five-year limited warranty when installed on an MMP system.
|MSH-RE Series Specifications|
|Input battery voltage range ||18 - 34 VDC|
|Nominal AC output voltage|| 120 VAC ± 3%|
|Output frequency and accuracy|| 60 Hz ± 0.05 Hz|
|Total Harmonic Distortion (THD)|| < 5%|
|1 msec surge current (amps AC) ||120|
|100 msec surge current (amps AC)|| 82|
|5 sec surge power (real watts) ||5800|
|30 sec surge power (real watts) ||5400|
|5 min surge power (real watts) ||4900|
|30 min surge power (real watts) ||4500|
|Continuous power output at 25° C ||4000 VA|
|Maximum continuous input current ||267 ADC|
|Inverter efficiency (peak) ||93.7%|
|Transfer time|| < 16 msecs|
|Search mode (typical)|| < 7 watts|
|No load (120 VAC output typical)|| 25 watts|
|Waveform ||Pure Sine Wave|
|Continuous output at 25° C ||110 ADC|
|Charger efficiency ||85%|
|Power factor|| > .95|
|Input current at rated output (AC amps)|| 29|