|SmartVent 100 |
Cat. No. SS-01100R01
Weight 3 lbs
Lack of ventilation and
condensation can be a problem in any enclosed
environment. Powered simply by sunlight the SmarVent helps keep more
pleasant and controlled atmosphere in your Sail Boat, RV, Camper or any
Powered by Sunlight
Silent secure ventilation
Easy to install - Wire Free
Helps to reduce condensation
Fits in polcarbonate, glass, wood, metal etc
No operating Costs
Two yeat warranty
Air out only
on off switch
Frosted Acrylic finish
It is important to locate your SmartVent so that it receive the maximum
amount of sunlight possible, ideally facing the midday sun and not in
If unsure how to fit the SmartVent yourself, consult a professional
- Remove the fixing ring
and gasket from the barrel.
- Draw a line around the
template in the packaging with a marker
- Cut out the hole,
diameter 115mm/4,5", using a suitable tool
- For added security
apply mastic sealant between the guidelines on
the underside of your SmartVent. NB In glass we recommend use of the
large foam gasket without using sealant.
- Place the product
through the hole from the outside. In wood or metal
screw SmartVent to the surface with suitable No. 8 or similar
- Push the fixing ring up
the barrel from the inside.
- If sealant has been used
wipe away any excess and leave to dry.
The SmartVent is supplied in the open position, however you can close
the SmartVent to waterproof the product in severe weather conditions.
To fully close the SmartVent hold the center ellipse area twist
counterclockwise and pull towards you until it locks into position. To
again, twist clockwise and push in until it locks into position. The
SmartVent is operated using the switches as described below.
To switch on, push the switch down into the on position, to switch off,
push the switch again and it will release to the off position. In the
on position the SmartVent will extract air when sufficient daylight
hits the solar cell.